Where Is The Reset Button On A Goodman Furnace?

Does A Goodman Furnace Have A Reset Button? - uooz.com

Resetting My Furnace: A Step-by-Step Guide

When my Goodman furnace went haywire, I was left confused and feeling helpless. Everywhere I looked I found instructions that were incomplete and seemed out of touch with my reality. I was close to giving up when I found the reset button. I want to save others from having to endure the same feeling of helplessness by providing a comprehensive guide on resetting your Goodman furnace.

Step One: Locate the Reset Button

The first step in the resetting process is to actually locate the reset button. Most Goodman furnaces will have the reset button located underneath the access panel. It is a very small button. To make it easier to locate, the button is often labeled verbatim with “reset” or “reset/restart.” Make sure the power is off before reaching for the reset button.

If you’re struggling to locate the button, look around the sides and front of the furnace unit for a small board. A small switch, button, or lever should be visible. This is the reset button.

Step Two: Press and Release the Reset Button

Once you’ve successfully located the reset button, press it and then quickly release it. A click should indicate that you have successfully pressed the button. If the reset button will not press down then you may need to have an HVAC technician come out to inspect the unit.

If you have difficulty pressing the reset button then you may need to slide the access panel back and look for screws that are holding it in place. After unscrewing the screws, use a flat head screwdriver to press down firmly on the reset button.

Step Three: Wait for the Furnace to Reset

After you’ve pressed the reset button correctly, it can take up to 30 seconds for the furnace to restart. You will then hear the fan inside the unit start up. This indicates that the resetting process was successful and the furnace is now ready to operate.

Step Four: Check the Air Filters

Once the resetting process has been completed, the next step is to check the air filters in your Goodman furnace. If the filters are dirty or clogged, then you should replace them as soon as possible. Dirty or clogged air filters can cause your furnace to overheat and restart or even stop working completely.

Inspecting and replacing the air filters every 3 months is important for proper maintenance of your furnace. This will help to prevent future episodes of overheating or stopping services.

Step Five: Listen To The Unit

Once you’ve checked and, if necessary, replaced the air filters, you should listen to the furnace for any loud noises that may indicate a problem. Turn the furnace on and check to see if it continues to operate without any loud banging or vibrating noises.

If you do hear a loud noise, then you may need to consult with an HVAC technician to diagnose the problem. It could be a bigger issue than a simple reset.

Step Six: Test For Heat

The final step in the resetting process is to test for heat. After you have listened to the furnace and determined that there are no loud noises, crank the thermostat up to its maximum temperature and wait to see if the furnace produces the correct amount of heat.

If the furnace does not produce the correct amount of heat then there may be a bigger issue preventing it from properly functioning. In that case, you should call an HVAC technician to diagnose and repair the problem.

Final Thoughts

Going through the furnace resetting process can be intimidating, especially for someone who has limited knowledge about HVAC systems. However, having a reliable guide and these simple steps to follow can help to make the process much easier and reduce the amount of time and stress involved.

I hope this guide has been helpful and you were able to reset your Goodman furnace and get it back to its normal operations. If not, contact an HVAC technician for help.